HP Designjet T3500 Production eMFP User Manual
Page 260
Table 26-2
Numerical error codes (continued)
Error code
Recommendation
63:10
●
Turn off the printer using the
Power
button at the front.
●
Turn off the power switch at the rear.
●
Disconnect the power cord.
●
Reconnect the power cord and turn on the printer.
●
Check that the network cable is correctly connected.
●
Ensure that the printer’s firmware is up to date. See
Update the firmware on page 159
63:20
A potential problem has been detected in the network interface.
●
Turn off the printer using the
Power
button at the front.
●
Turn off the power switch at the rear.
●
Disconnect the power cord.
●
Reconnect the power cord and turn on the printer.
●
Send the same job to the printer again.
●
Ensure that the printer’s firmware is up to date. See
Update the firmware on page 159
71.03, 71.08
Out of memory. To avoid this, in the HP-GL/2 driver select the Advanced tab and then Send job as a
bitmap.
74.01
An error occurred when loading the firmware update file.
●
Turn off the printer using the
Power
button at the front.
●
Turn off the power switch at the rear.
●
Disconnect the power cord.
●
Reconnect the power cord and turn on the printer.
●
Reload the firmware update file into the printer. See
Update the firmware on page 159
.
74.1:04
Try the firmware update again. Do not try to use your computer while the update is in progress.
74.8:04
The firmware update has failed. Your firmware file may be incorrect; try to download it again. See
Update the firmware on page 159
75.11:10
Preventive maintenance 1 is recommended. See
.
75.21:10
Preventive maintenance 2 is recommended. See
.
76:03
The printer’s hard disk is full. You may want to use Disk Wipe to free some space; see
78:08
Borderless printing not possible; setting ignored. Ensure that the loaded paper supports borderless
printing.
79:03, 79:04
Update the printer's firmware. See
Update the firmware on page 159
81:01
Open the scanner and make sure that there are no obstacles restricting the movement of the drive
roller. If the paper has jammed, clear the obstruction by following the instructions in the front
panel.
250 Chapter 26 Front-panel error messages
ENWW