HP Netserver L Server series User Manual
Page 166
Index
160
set up IP addresses, 23
set up server groups, 23
set up server names, 23
device
rebuild options, 130
Device Information
ANSI version support, 104
bus width, 104
Command Queuing, 104
displaying, 103
hardware revision level, 104
Linked, 104
product identification, 104
Soft Reset, 104
Synch, 104
transfer speed, 104
vendor, 104
devices to spin up, 51
disk array controller
FCArray Assistant Client, 1
disk arrays
automatically configure, 3
FCArray Assistant Client, 1
manually configure, 3
semi-automatically configure, 3
disk drive
ANSI version support, 105
bus width, 105
Command Queuing, 105
current status, 105
firmware version, 105
hard errors, 105
Linked, 105
negotiated bus width, 105
negotiated transfer speed, 105
parity errors, 105
physical capacity, 105
product identification, 105
rebuild, 105
reset errors, 105
sector size, 105
soft errors, 105
Soft Reset, 105
Synch, 105
vendor, 105
Display Controller Information
Administration menu, 23
icon, tool bar, 26
drive
3-½ in. floppy disk, 4
CD-ROM, 4
rebuild options, 130
software installation, 4
drive initializations
cancel, 121
drive spin-up, 51
drive, new
rebuild data, 130
drives
cancel rebuild, 123
Dual Active
shutdown, 138
Dual Active Configuration
redundant controller system, 80
Dual Active configurations, 80
also Active/Active, 80
dual active controllers
double-pointed white arrow, 18
pair selection, 18
Dual Active mode
requires two controllers, 80
E
edit Event ID, 48
e-mail
disable, 44
enable, 44
subject, 44
test settings, 44
add e-mail, 43
remove e-mail, 44
E-mail, 38
error message
Intelligent BBU, 58
Error Table