HP 3000 Enterprise Virtual Array - Manual (Page 196)

SNMP trap configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose from Trap 1 to Trap
8 to configure each trap.
Table 33 describes the parameters for configuring an SNMP trap.
Table 33 SNMP parameters
Description Parameter
Enables or disables trap n. If disabled, the trap is not configured. Trap n Enabled
Specifies the IP address to which the SNMP traps are sent. A maximum of
8 trap addresses are supported. The default address for traps is 0.0.0.0.
Trap Address
1
The port number on which the trap is sent. The default is 162. Trap Port
1
Specifies the SNMP version (1 or 2) with which to format traps. Trap Version
1
Trap address (other than 0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2 have the same
address, then they must have different port values. Similarly, if trap 1 and trap 2 have the same port value, they must have
different addresses.
Management Information Base
The following sections describe the components of the Management Information Base (MIB):
• System information , page 196
• Network port table , page 197
• Fibre Channel port table , page 200
• Sensor table , page 202
System information
The system information objects provide the system serial number, version numbers
(hardware/software/agent), and number of ports (FC/GE).
qsrSerialNumber
SnmpAdminString Syntax
read-only Access
The system serial number Description
qsrHwVersion
SnmpAdminString Syntax
read-only Access
The system hardware version number Description
Simple Network Management Protocol 196