HP 3000 Enterprise Virtual Array - Manual (Page 156)

Set NTP command
Configures NTP parameters.
Admin session Authority
set ntp Syntax
port_num : The number of the iSCSI port to be configured for iSNS. Parameters
The following is an example of the Set NTP command:
mpx100 (admin) #> set ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the Enter key to do so.
NTP (0=Enable, 1=Disable) [Enabled ]
TimeZone Offset from GMT (Min=-12hrs,Max=12hrs) [-8 ]
IP Address [0] [0.0.0.0 ] 207.126.97.57
IP Address [1] [0.0.0.0 ]
IP Address [2] [0.0.0.0 ]
All attribute values that have been changed will now be saved.
Examples
Set Properties command
Configures both the Inactivity Timer and the CLI Prompt name.
Admin session only Authority
set properties Syntax
The following is an example of the set properties command:
mpx100 (admin) #> set properties
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the Enter key to do so.
CLI Inactivty Timer (0=Disable, 1=15min, 2=60min) [15min ] 1
CLI Prompt (Max=32 Characters)
[mpx100 ] mpx100
All attribute values that have been changed will now be saved.
Examples
Set SNMP command
Configures the general SNMP properties. Also configures up to eight trap destinations.
Admin session Authority
set snmp Syntax
Command line interface 156