HP 3000 Enterprise Virtual Array - Manual (Page 195)

D Simple Network Management Protocol
SNMP provides monitoring and trap functions for managing the router through third-party applications
that support SNMP. The mpx100/100b firmware supports SNMP versions 1 and 2 and an HP MIB
“
Management Information Base (MIB) ” on page 196. Traps can be formatted using SNMP versions 1
or 2 “ Notifications ” on page 204.
This appendix contains the following sections:
• SNMP properties , page 195
• SNMP trap configuration , page 196
• Management Information Base (MIB) , page 196
• Notifications , page 204
SNMP properties
The SNMP properties can be set using either the CLI or the GUI. Table 32 describes the SNMP
properties.
Table 32 SNMP properties
Description Parameter
Read community password that authorizes an SNMP management server to read inform-
ation from the router. This is a write-only field. The value on the router and the SNMP
management server must be the same. The read community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The default is public.
Read Community
Trap community password that authorizes an SNMP management server to receive traps.
This is a write-only field. The value on the router and the SNMP management server must
be the same. The trap community password can be up to 32 characters excluding #,
semicolon (;), and comma (,). The default is public.
Trap Community
Specifies the name of the router location. The name can be up to 64 characters excluding
#, semicolon (;), and comma (,). The default is undefined.
System Location
Specifies the name of the person to be contacted to respond to trap events. The name
can be up to 64 characters excluding #, semicolon (;), and comma (,). The default is
undefined.
System Contact
Enables or disables the generation of authentication traps in response to authentication
failures. The default is disabled.
Authentication Traps
EVA iSCSI Connectivity User Guide 195