beautypg.com

Ibm xiv series, Fujitsu fibrecat cx series, Fujitsu dx60/80/90 s2 and fujitsu dx400 s2 – HP XP P9500 Storage User Manual

Page 72

background image

Set system parameters according to the following table. For connection parameters not shown,
refer to IBM SVC series documentation.

Parameter Setting

Parameter

Generic

host type

IBM XIV series

The port must be configured as a target attached to a Windows host.
Device serial number differs between IBM XIV series and the HP P9500, as shown in the following
table.

Display in IBM XIV

Display in HP P9500

Type

Item

Type

Item

Decimal value

First 2 digits of (System) Serial
number

Decimal value

First 2 digits of Serial Number

Decimal value

Last 5 digits of (System) Serial
number

Hexadecimal value

Last 5 digits of Serial Number

Decimal value

Device serial number

Hexadecimal value

Characteristic 1

Fujitsu FibreCAT CX series

The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to Fujitsu FibreCAT CX series documentation.

Parameter Setting

Parameter

CLARiiON Open

Initiator Type

2

Failover Mode

Volumes created with the RAID0 level or Individual Disk Units (JBOD disks) of Fujitsu FibreCAT CX
series are not supported.

System option mode for connecting Fujitsu FibreCAT CX series

When you connect the Fujitsu FibreCAT CX series as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when maintenance tasks such as rebooting the controller of the external storage
system is performed before the firmware update. For more information about using SOM 725, log
on to the HP Support Portal for contact information.

Fujitsu DX60/80/90 S2 and Fujitsu DX400 S2

The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to Fujitsu DX60/80/90 S2 or Fujitsu DX 400 S2 documentation.

Parameter Setting

Parameter

Type1 + Type3

Inquiry VPD ID Type in Setup Host Response screen

Busy

Load Balance Response in Setup Host Response screen

72

Supported external storage systems