HP XP P9500 Storage - Manual (Page 69)

Sun StorEdge 6120/6320
System option mode for connecting Sun StorEdge 6120/6320
When you connect Sun StorEdge 6120/6320 as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when performing maintenance tasks such as rebooting the controller of the
external storage system before the firmware update.
For more information about using SOM 725, log on to the HP Support Portal to obtain contact
information.
System option parameters for connecting Sun StorEdge 6120/6320
The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to the Sun StorEdge 6120/6320 system documentation.
On the local HP P9500 storage system, set system option mode 725 to ON for support of Sun
online maintenance operation.
Parameter Setting Parameter
SUN port host
Sun StorageTek FlexLine 380
System option mode for connecting Sun StorageTek FlexLine 380
When you connect Sun StorageTek FlexLine 380 as an external storage system, you must set SOM
725 of the local storage system to ON. If SOM 725 is not set to ON, the external storage system
might be blocked when performing maintenance tasks such as rebooting the controller of the
external storage system before the firmware update.
For more information about using SOM 725, log on to the HP Support Portal to obtain contact
information.
System option parameters for connecting Sun StorageTek FlexLine 380
The port must be configured as a target attached to a Windows host.
Set system parameters according to the following table. For connection parameters not shown,
refer to the Sun StorageTek FlexLine 380 documentation.
Parameter Setting Parameter
Windows Non-clustered (DMP Support) host type
Sun StorageTek 2540
System option mode for connecting Sun StorageTek 2540
When you connect Sun StorageTek 2540 as an external storage system, you must set SOM 725
of the local storage system to ON. If SOM 725 is not set to ON, the external storage system might
be blocked when performing maintenance tasks such as rebooting the controller of the external
storage system before the firmware update.
For more information about using SOM 725, log on to the HP Support Portal to obtain contact
information.
System option parameters for connecting Sun StorageTek 2540
The port must be configured as a target attached to a Windows host.
Sun StorEdge 6120/6320 69