HP StorageWorks XP10000 Disk Array - Manual (Page 31)

Command Line Interface Commands 31
• Yes: System Administrator, Storage Administrator
• No: Guest, Local Guest
• Restricted: A Local System Administrator or Local Storage Administrator can use this command only
when updating the registered information.
NOTE: When you are performing this command, do not shut down the hosts that are using storage
subsystem volumes, or the host for the Device Manager agent, or execution might take longer.
Format for StorageWorks XP12000/XP10000 and StorageWorks XP1024/XP128:
hdvmcli [URL] AddStorageArray [options] ipaddress=IP address family=array-family
(displayfamily=array-family-to-be-displayed) [userid=user-name arraypasswd=user-password]
Format for StorageWorks XP512/XP48:
hdvmcli [URL] AddStorageArray [options] ipaddress=IP address family=array-family
(displayfamily=array-family-to-be-displayed) [searchcommunity=searchcommunity]
Table 4-12 AddStorageArray Command Parameters
Parameter Name Status Description
arraypasswd
Optional
(XP12000/XP10000
and XP1024/XP128
only) User password for array access.
For StorageWorks XP12000/XP10000 and XP1024/XP128, required only at
the initial identification.
If you are refreshing information, you can omit this parameter if the user
password was not changed.
displayfamily Optional Display array family of the target array.
This parameter is required at the initial identification. Obtain the values
available for this parameter from the execution result of the GetServerInfo
command. In the execution result of this command, a combination of the
arrayFamily
and displayArrayFamily values appears. For the
StorageWorks XP Disk Array, use the displayArrayFamily value to
specify the family and displayfamily parameters.
family
Required Array family of the target array.
ipaddress Required Array IP address.
searchcommunity Optional
(XP512/XP48 only) SNMP Community string, used for identifying device elements via SNMP
(StorageWorks XP512/XP48 array). Default is public.
userid Optional
(XP12000/XP10000
and XP1024/XP128
only) User ID for array access.
For StorageWorks XP12000/XP10000 and StorageWorks XP1024/XP128,
required only at the initial identification.
When refreshing information, you can omit this parameter if the user ID was
not changed.
Command execution example: In this example, the CLI command accesses and detects the storage
subsystems in an array family (family: XP1024/128, IP address: 172.16.45.1). The command specifies the
user ID (root) and the user password (hdvm). Information about the detected storage subsystems is
registered in the Device Manager database.
hdvmcli AddStorageArray -o "D:\logs\XP1024 AddStorageArray.log" ipaddress=172.16.45.1
family=XP1024/128 userid=root arraypasswd=hdvm displayfamily=XP1024/128
Command execution result:
RESPONSE:
An instance of StorageArray
objectID=ARRAY.HDS9980V.10001
[email protected]
description=XP1024 (10001) at 172.16.45.1
serialNumber=10001
arrayFamily=HDS9900V
arrayType=HDS9980V
microcodeVersion=21-03-00/00