HP StorageWorks XP10000 Disk Array - Manual (Page 27)

Command Line Interface Commands 27
Table 4-9 AddHostStorageDomain Command Parameters
Parameter Name Status Description
nickname Optional
(StorageWorks
XP12000/XP10000
and XP1024/XP128) Nickname of the Host Storage Domain.
The maximum number of characters that can be used for a nickname is as
follows:
StorageWorks XP12000/XP10000: 16 bytes
DKC microcode version 50-04-01 or later: 32 bytes
StorageWorks XP1024/128: 8 bytes
serialnum Required Serial number of the storage array for the Host Storage Domain.
Command execution example:
hdvmcli AddHostStorageDomain -o "D:\logs\XP12000 AddHostStorageDomain.log"
"serialnum=11111" "model=XP12000" "port=16" "domain=1" "hostmodeoption=2"
Command execution result:
RESPONSE:
An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 HostStorageDomain elements:
An instance of HostStorageDomain
objectID=HSDOMAIN.USP.11111.16.1
portID=16
domainID=1
hostMode=Standard
hostModeOption=2
displayName=CL1-E-1
nickname=HCMD1001
4-3-3 AddLogicalUnit
AddLogicalUnit
creates an LDEV and logical unit in Device Manager (see Table 4-10 ). When executed, this
command also formats the logical devices that it creates.
Users with access to this command:
• Yes: System Administrator, Storage Administrator
• No: Guest, Local System Administrator, Local Storage Administrator, Local Guest
When executed, this command also formats the logical devices that it creates.
NOTE: You cannot create an LDEV that is the same size as the free space of the array group, because the
control area is created on the storage subsystem side.
Table 4-10 AddLogicalUnit Command Parameters
Parameter Name Status Description
serialnum
Required Serial number of the storage array where LU is added.
model
Required Model of the storage array where the LU is added.
chassis Required Number of chassis for the array group where LU is added.
groupnum Required Group number of the array group where LU is added.
capacity
Required Desired capacity (in KB) for the new LU.
The specified value is adjusted, depending on the minimum unit that is set to
the volume size of each storage subsystem. Therefore, the size of the logical
unit that was actually created might exceed the specified value.