HP Matrix Operating Environment Software - Manual (Page 45)

a. Set the vcenterIp property.
Specify the IP address that the vSphere vCenter service was configured to listen on. This
is typically the management network that vCenter and the VM Hosts share for management.
The CMS must have connectivity to this network, which requires that the CMS is on the
management network.
i.
Expand the Configuration node.
ii. Expand the System Properties node.
iii. Double click the vcenterIp property.
iv.
Click the Lock button to check out the property.
v. Update the property value with IP address of the vCenter Server.
vi. Click Save and Check in.
b. Repeat step a to specify the DepotURL property.
Update the property value to point to the ESX Software Depot.
NOTE: If a service was previously created for the target VM Host, the assigned profile
is associated with that VM Host. If a service has not been associated with a VM Host in
vCenter, the value in DepotURL is used.
10. Configure the IO service template to call Operations Orchestration workflows.
a. In infrastructure orchestration designer, select the service template and edit the server
group configuration. Click Workflows, then click Add.
b. Click Select workflow from tree, and click ++ to expand the tree.
Be sure to order the workflows as they are numbered and as they are shown in the
Summary tab screenshot below.
c. Select 00_ConfigureVMADBootProfile_server_begin, click the Configure Server Beginning
checkbox, and click Add.
d. Click Add and expand the tree by clicking ++.
Configuring an environment for ESXi cluster provisioning 45