NORD Drivesystems BU0000 - Manual (Page 40)

NORD CON Manual
40 BU 0000 GB
Char Name Description
value can be given as a 32 Bit value.
"H" 32 Bit High-Word By this formatting the setpoint and actual value are taken as the
high word (16 Bit) of a 32 Bit word. (see "32 Bit Low-Word").
"P" 16 Bit Posicon Arr control clamps
(SK7xx, Vector CT with Posicon) By this formatting the setpoint and actual value are taken as the
„Posicon position array". The meaning of each bit you can find in
the Posicon manual. This option is only available for inverter with
Posicon functionality.
"I" 16 Bit Posicon Inc control clamps
(SK7xx, Vector CT with Posicon) By this formatting the setpoint and actual value are taken as
„Posicon position increment array". You can find the meaning of
each bit in the Posicon manual. This option is only available for
inverter with Posicon functionality.
"32" 32 Bit standardised (SK7xx, Vector
CT with Posicon) By this formatting the setpoint and actual value is taken as an 32
Bit value without standadisation. This option is only available for
inverter with Posicon functionality.
5.3.5 Control word
The present status word is displayed with each bit in the window „status word". All bits are listed
in a table including bit number, name and status. According to bit value and function there is a
coloured LED shown.
Importance of LEDs:
LED Importance
The Bit is set and/or the inverter is enabled.
An error is active or an enable signal is missing.
The Bit is not set.
With the standard setting the status word is read in cycles and the changes are displayed in the
window. For deactivating the cyclic reading switch off the function „automatic" in the menu (right
mouse click).
The window is docked left next to the „control" window. If the window should be free on desktop,
you should choose the popup menu "docking/no". To save space the window can be added as
an index card next to the index card „general". To do this the window must be moved (pressed
left mouse button) over the index card "general". After release of the button the window is
shown as an index card. With double click (left mouse button) on the index card you get back to
window mode.