NORD Drivesystems BU0000 - Manual (Page 32)

NORD CON Manual
32 BU 0000 GB
Aktion Place Description
A selection is possible as to whether this operation is to be
performed on all parameters or only on those belonging to
the current menu group.
Send Factory settings Parameterize -> Send ->
Reset values
The settings transmitted will be the default settings of all
parameters or of the parameters of the current menu group
respectively
Selection Enable Parameterize -> Selection ->
Release All of the parameters (or those included in the current
menu group respectively), are enabled.
Selection Disable Parameterize -> Selection ->
no Release None of the parameters (or of those belonging to the
current menu group), are enabled.
Standard Button "Standard" The default value is allocated to the currently selected
parameter.
Send Button "Send" The value "new setting" of the current parameter is
transferred to the inverter
Read Button "Read" The selected parameter is read out and the value
transferred to the 'Current Setting' box.
With the Auto-read option the selected parameter is read out automatically.
4.4 Selective parameterization
NORD CON allows for masking some parameters or other, a feature which may facilitate
manipulation or serve the purpose of restricting parameter readout or transmission to those
which remain unmasked or in other words have been filtered out.
Note
When a filter has been activated, all operations are executed only on those parameters which
are displayed.
Before any parameter can be masked the enable command must be inactivated. This can be
done using the checkbox preceding the parameter, or via the Selection menu. The
Filter box
provides for the setting options mentioned below :
Selection only Only the enabled parameters are displayed (i.e. where the check box
preceding the parameter was clicked upon once).
No standard Only the parameters with a value that is different from the standard setting are
displayed.
Info parameters
Yes Information parameters are displayed.
No Information parameters are not displayed.
Only Information parameters are displayed exclusively.