FUTEK VCal Sensor Verification User Manual
Page 52
Futek Advanced Sensor Technology – Futek VCal™Documentation
Rev. 1.8.0
07/26/05
©Futek Advanced Sensor Technology 2005
52
5. Under the Search section of the Print Options interface, you can bring up a previously saved Certificate by entering a known Certificate Number,
or you can search for a particular test to print by entering the sensor Serial Number, pressing
Enter
, and then selecting the specific test you wish
to print by double clicking on it, and then pressing Print. Please note that to print a Certificate, you must select one, and only one test at a time,
6. This will bring up the “Print Settings” screen where you can choose exactly which sections are or are not included in your Certificate. Under
Template with
Standard
selected;
Test Counter
,
Calibrated With
,
Best Fit Equations
,
Extended Test Results
,
Max Non-Linearity,
and
Max Hysteresis
are all sections that you can choose to include or not include. Under Template with
Custom
selected; all of the above-mentioned sections, and also
Customer Address
and
Last Page Statements
(Calibration Technician, etc.) can be selected for including or excluding from your Certificate.
Print Options Interface
Print Settings Screen
7. Once you have decided on, and selected all of the Sections you wish to include on your Report or Certificate, then pressing
will either
allow you to preview the certificate (if you selected the Show Settings Before Printing checkbox on the Print Options interface), or print the Report
On the following pages is an example of the Standard Mode Calibration Certificate with all Sections selected…