FUTEK VCal Sensor Verification - Manual (Page 10)

Futek Advanced Sensor Technology – Futek VCal™Documentation Rev. 1.8.0 07/26/05
©Futek Advanced Sensor Technology 2005 10
Installation of Your VCal™ System
We recommend installing your VCal™ from the included installation CD; however you may also install from the VCal™ module.
From CD: If you have AutoPlay enabled simply plug in and follow the instructions on the screen. If not, you will need to open your CD
drive and run the Setup program from there. From VCal™: You will need to open the Removable Disk that VCal™ created, open the
Setup Folder, and run the VCal.msi installation program. Either method will work equally well; whichever method you use, please note
the following:Minimum Requirements: It is recommended that your VCal™ be installed on a PC running either Windows 2000 or
Windows XP; and with a Pentium II, 400 MHz or better, with an available USB port, and with a screen resolution of 1024 x 768, 256
colors, MDAC 2.7 (available at www.microsoft.com), all the latest service releases and updates (both critical and Windows) for you
roperating system, 100 MB of free disk space. You are also responsible for your PC’s hardware and BIOS updtaes and drivers.
The exact screens you will see after starting the installation CD will vary depending on your PC system’s setup and configuration.
However, no matter what your operating system or configuration they should all progress through the following steps in one form or
another.
Note: Windows XP users may encounter a message regarding Windows Logo Testing and incompatibility: we ask that you
please disregard this message and continue with the installation. We are in the process of working this issue out.
1. First you should see the Futek Vcal™ Installation opening screen...
2. Clicking Next brings up the Welcome to VCal™ Setup screen...