FUTEK VCal Sensor Verification User Manual
Page 13
Futek Advanced Sensor Technology – Futek VCal™Documentation
Rev. 1.8.0
07/26/05
©Futek Advanced Sensor Technology 2005
13
7. Once the installation is complete you will see the Installation Complete screen, simply click
Close
here and your VCal™
installation is complete!
Connecting Your VCal™ System
Now that you have successfully installed your Futek VCal™ system, it is time to connect your VCal™. Futek VCal™ is very simple to
connect. For best results we recommend that you connect your VCal™ in the following manner; Please note the General Safety pre-
cautions listed on
(page 57)
before connecting your VCal™.
1. Plug in the DC Power Supply (included with your VCal™) into the wall outlet and then into your VCal™ unit.
2. Push in the
ON/OFF power button
, the red power LED should light.
3. Plug the USB cable (included with your VCal™) into the USB outlet on your PC
4. Plug the USB cable into your VCal™ unit, and plug your Temperature Probe into the connector on the
Power Face Plate.
5. Your Futek VCal™ unit is now connected.
6. After connecting your VCal™ you should first see the Found New Hardware Screen...