KROHNE IFC 050 Converter EN - Manual (Page 73)

TECHNICAL DATA
8
73
IFC 050
www.krohne.com 08/2013 - 4002184002 - MA IFC 050 R02 en
Operating conditions
Temperature Temperature Temperature Temperature
Process temperature Refer to technical data for the measuring sensor.
Ambient temperature Depending on the version and combination of outputs.
It is a good idea to protect the converter from external heat sources such as direct
sunlight as higher temperatures reduce the life cycle of all electronic components.
Ambient temperatures below -25°C / -13°F may affect the readability of the display.
Storage temperature -40…+70°C / -40…+158°F
Pressure Pressure Pressure Pressure
Medium Refer to technical data for the measuring sensor.
Ambient pressure Atmosphere
Chemical properties Chemical properties Chemical properties Chemical properties
Electrical conductivity All media except for water: ≥ 5 µS/cm
(also refer to the technical data for the measuring sensor)
Water: ≥ 20 µS/cm
State of aggregation Conductive, liquid media
Solid content (volume) ≤ 10%
Gas content (volume) ≤ 3%
Flow rate For detailed information, refer to chapter "Flow tables".
Other conditions Other conditions Other conditions Other conditions
Protection category acc. to
IEC 529 / EN 60529
IP66/67 (acc. to NEMA 4/4X)
Installation conditions
Installation For detailed information, refer to chapter "Installation conditions".
Inlet / outlet sections Refer to technical data for the measuring sensor.
Dimensions and weight For detailed information refer to chapter "Dimensions and weights".
Materials
Signal converter housing Aluminium with a polyester topcoat
Measuring sensor For housing materials, process connections, liners, grounding electrodes and
gaskets, refer to technical data for the measuring sensor.