KROHNE IFC 050 Converter EN - Manual (Page 15)

INSTALLATION
3
15
IFC 050
www.krohne.com 08/2013 - 4002184002 - MA IFC 050 R02 en
3.4 Installation specifications
3.5 Mounting of the compact version
3.6 Mounting of the wall housing, remote version
1 Prepare the holes with the aid of the mounting plate. For further information refer to Mounting
plate, wall version on page 80.
2 Fasten the device securely to the wall with the mounting plate.
INFORMATION!
The following precautions must be taken to ensure reliable installation.
• Make sure that there is adequate space to the sides.
• Protect the signal converter from direct sunlight and install a sun shade if necessary.
• Signal converters installed in control cabinets require adequate cooling, e.g. by fan or heat
exchanger.
• Do not expose the signal converter to intense vibrations. The measuring devices are tested
for a vibration level in accordance with IEC 68-2-64.
INFORMATION!
The signal converter is mounted directly on the measuring sensor. For installation of the
flowmeter, please observe the instructions in the supplied product documentation for the
measuring sensor.
INFORMATION!
Assembly materials and tools are not part of the delivery. Use the assembly materials and tools
in compliance with the applicable occupational health and safety directives.
Figure 3-1: Mounting of the wall housing