KROHNE OPTISONIC 6300 P-6400 EN - Manual (Page 52)

6
OPERATION
52
OPTISONIC 6300 P
www.krohne.com 03/2013 - 4000972603 - MA OPTISONIC 6300 P R03 en
6.1 Display configuration
6.1.1 Step 1: how to set up the display for showing measured values
There are two ways of setting up screens for showing measured values. Standard 4 information
screens can be shown in the measuring mode. Additional screens showing graphs can be added
when the datalogger is used. Setting up the display is done in menu nr. 2.4.3.1 via "Measurement
Setup Display Screen setup". The following menu will be shown. Page 1 and 2 show
parameters in numeric values or bar graphs or both, the graphical page shows trend graphs.
The fourth page shows status and error messages.
The appearance of the screens can be set. None (cyclic) means that the screen page will cycle
through the 4 screens automatically. It is possible to define the default screen to display, for
instance "1st meas. page".
• Select 1st meas. page
• Presentation mode: Program the number of lines (number of parameters) to be shown.
• Low flow cutoff threshold and hysteresis: Use the default values.
• Time constant: Only change the default value to a higher value if the signal is unstable.
• Line 1: Select the parameter to be shown and set the display format.
2.4.3.1
Page 1
Page 2
Graphical page
Default page Default page Default page Default page None (cyclic)
13-04-2010 14:11:09 13 MB free
2.4.3.1.4
None (cyclic)
1st meas. page 1st meas. page 1st meas. page 1st meas. page
2nd meas. page
Graphical page
Status page
13-04-2010 14:11:09 13 MB free
2.4.3.1.1
Presentation mode 1 Presentation mode 1 Presentation mode 1 Presentation mode 1
Low flow cutoff threshold
Low flow cutoff hysteresis
Time constant
Line 1
1 line
0 %
0%
0.1 s
13-04-2010 14:11:09 13 MB free
INFORMATION!
2nd meas. page can be programmed in the same way.