GW Instek PCS-1000 - Manual (Page 64)

PCS-1000 User Manual
64
Query Example CONF:VOLT?
>”DC 0.1”
The mode is DCV and the range is 200mV.
Note
The range that is returned is the base voltage unit. See
the table below:
Unit Voltage Range
1000 1000VDC
600 600ACV
100 200V
10 20V
1 2V
0.1 200mV
CONFigure:VOLTage[:DC]
Set
Description This command will set the voltage mode to DC
and set the DCV range. If the range is not specified
then it will not be changed.
Syntax CONFigure:VOLTage[:DC] [ | AUTO]
Parameter Voltage range : 0.0000001 ~ 1050
The unit will automatically be set to the
closest range.
AUTO Autoset
Example CONF:VOLT:DC 20
Sets the voltage mode to DC and the DCV range to
20V.
Example CONF:VOLT:DC
Sets the voltage mode to DC. The range stays the
same.