GW Instek PCS-1000 - Manual (Page 44)

PCS-1000 User Manual
44
Interface Configuration
Configure GPIB Interface
To use GPIB the GPIB address must first be set.
Configure GPIB 1. Connect the GPIB cable from the GPIB
controller to the PCS-1000.
2. Turn the PCS-1000 on.
3. Long push Func key to enter the
function menu.
Page 31
4. Use the ◄ Func ► keys to go to the ADDRESS
function.
5. Select the address using the ▼Select ▲ keys.
GPIB Address 00~30
6. Press the Enter key to confirm the selection.
Note
RMT will be displayed on the screen when the unit
is remote mode.
GPIB constraints  Maximum 14 devices altogether, 20m cable
length, 2m between each device
 Unique address assigned to each device
 At least 2/3 of the devices turned On
 No loop or parallel connection