GW Instek AFG-2000 User Manual - Manual (Page 76)

AFG-2000 Series User Manual
74
7. Use the scroll
wheel or keypad to
choose the vertical
value of the
selected point.
or
0 /
3 2 1
4
7 8
5
9
6
Use the Enter key
to confirm the
point value.
Enter
Range Value: ±511 (10-bit vertical resolution)
8. Repeat steps 2 to 7 for the remaining points of
the ARB waveform.
Note
The horizontal position of the points depends on the
set frequency. For example, if the set frequency is 1kHz
(period = 1ms), then each point will be located every
0.01ms (1ms/sample rate).
Example:
Point “0” is set to
+511.
Note
To save the ARB data, please see the Save/Recall
section on page 81.