GW Instek AFG-2000 User Manual - Manual (Page 128)

AFG-2000 Series User Manual
126
SOURce[1]:SWEep:SPACing
Set
Query
Description Sets linear or logarithmic sweep spacing. The
default spacing is linear.
Syntax SOURce[1]:SWEep:SPACing {LINear|LOGarithmic}
Example SOUR1:SWE:SPAC LIN
Sets the spacing to linear.
Query Syntax SOURce[1]:SWEep:SPACing?
Return Parameter LIN Linear spacing
LOG Logarithmic spacing
Query Example SOUR1:SWE:SPAC?
>LIN
The spacing is currently set as linear.
SOURce[1]:SWEep:RATE
Set
Query
Description Sets or queries the sweep rate. The default sweep
rate is 100 Hz. This command is the equivalent to
using the Rate function on the front panel.
Note
The function generator automatically determines
the number of frequency points that are used for
the sweep based on the sweep rate.
Syntax SOURce[1]:SWEep:RATE
{|MINimum|MAXimum}
Parameter 2mHz ~1kHz (equivalent to a sweep
time of 500s ~ 1ms)
Example SOUR1:SWE:RATE +1.0000E+00
Sets the rate to 1 Hz (1 second).
Query Syntax SOURce[1]:SWEep:RATE? {|
MINimum|MAXimum}
Return Parameter Returns sweep rate in Hz.