GW Instek AFG-2000 User Manual - Manual (Page 126)

AFG-2000 Series User Manual
124
SOURce[1]:SWEep:STATe
Set
Query
Description Sets or disables Sweep mode. By default sweep is
disabled. Sweep must be enabled before setting
other parameters.
Note
Any modes will be disabled if sweep mode is
enabled.
Syntax SOURce[1]:SWEep:STATe {OFF|ON}
Example SOUR1:SWE:STAT ON
Enables sweep mode.
Query Syntax SOURce[1]:SWEep:STATe?
Return Parameter 0 Disabled (OFF)
1 Enabled (ON)
Query Example SOUR1:SWE:STAT?
>1
Sweep mode is currently enabled.
SOURce[1]:FREQuency:STARt
Set
Query
Description Sets the start frequency of the sweep. 100Hz is the
default start frequency.
Note
To sweep up set the stop frequency higher than the
start frequency. Set the stop frequency lower than
the start frequency to sweep down.
Syntax SOURce[1]:FREQuency:STARt
{|MINimum|MAXimum}
Parameter 0.1Hz ~ 25MHz*
0.1Hz ~ 1MHz (Ramp)
*AFG-2112 limited to 12MHz, AFG-2105 limited to
5MHz.