GW Instek GDS-1000A-U Series Programming Manual - Manual (Page 61)

COMMAND DETAILS
61
Note Before any Go-NoGo command can be used,
please use the :GONogo:FUNCtion 1 command to
initialize the oscilloscope.
Syntax < Long > < Short >
:TEMPlate:MODe {0|1}
:TEMPlate:MODe? :TEMP:MOD {0|1}
:TEMP:MOD?
Parameter/
Return parameter 0 Select Normal template mode.
1 Select Auto template mode.
Example :TEMP :MOD 1 Set to Auto mode.
:TEMPlate:MAX
Set
Query
Description Sets or queries the template used for the MAX
boundary (W1~W15, RefA).
Note A template can only be defined for the MAX or
MIN template, not both.
Before this command can be used, please set the
template mode to normal using
the :TEMPlate:MODe 0 command.
Before any Go-NoGo command can be used,
please use the :GONogo:FUNCtion 1 command to
initialize the oscilloscope.
Syntax < Long > < Short >
:TEMPlate:MAX
:TEMPlate:MAX? :TEMP:MAX
:TEMP:MAX?
Parameter/
Return parameter 0 Set RefA as the MAX template.
1~15 Set W1 ~ W15 as the MAX template
Example :TEMP :MAX ?
>1 RefA is the template.