GW Instek GDS-1000A-U Series Programming Manual - Manual (Page 57)

COMMAND DETAILS
57
Go No-Go Commands
:GONogo:CLEar ...........................................................57
:GONogo:EXECute ......................................................58
:GONogo:FUNCtion ....................................................58
:GONogo:NGCount? ...................................................59
:GONogo:NGDefine ....................................................59
:GONogo:SOURce .......................................................59
:GONogo:VIOLation ....................................................60
:TEMPlate:MODe ........................................................60
:TEMPlate:MAX ............................................................61
:TEMPlate:MIN ............................................................62
:TEMPlate:POSition:MAX ............................................62
:TEMPlate:POSition:MIN ............................................63
:TEMPlate:SAVe:MAXimum ........................................64
:TEMPlate:SAVe:MINimum ........................................65
:TEMPlate:TOLerance ..................................................65
:TEMPlate:SAVe:AUTo .................................................66
:GONogo:CLEar
Set
Description Clears the Go No-Go test result ratio.
This is the equivalent to clearing the “failed” to
“total tests” result ratio as shown in the Go-NoGo
menu.
Same as: Utility key → More (F4) →Go-NoGo
Menu(F1)→Ratio:(F5).
Note Before any Go-NoGo command can be used,
please use the :GONogo:FUNCtion 1 command to
initialize the oscilloscope.
Syntax < Long > < Short >
:GONogo:CLEar :GON:CLE