GW Instek GDS-1000A-U Series Programming Manual - Manual (Page 19)

COMMAND DETAILS
19
Acquisition Command
:ACQuire:AVERage .......................................................19
:ACQuire:HDELay ........................................................20
:ACQuire:MODe ..........................................................20
:ACQuire:LMEMory ...............................................21
:ACQuire:MEMory .................................................22
:ACQuire:AVERage
Set
Query
Description Selects or returns the average number of waveform
acquisitions (samples) used in the average
acquisition mode.
Same as: Acquire key → F2
Syntax < Long > < Short >
:acquire:average
:acquire:average? :acq:aver
:acq:aver?
Parameter Average No. Average No.
0 Off 5 32
1 2 6 64
2 4 7 128
3 8 8 256
4 16
Note Before using this command, select the average
acquisition mode. See the example below.
Example :acquire:mode 2
:acquire:average 2 Selects the average
acquisition mode, and
sets the number of
samples to 4.