GW Instek GDS-1000A-U Series Programming Manual - Manual (Page 35)

COMMAND DETAILS
35
Cursor Command
:CURSor:XPosition ................................................35
:CURSor:YPosition ................................................36
:CURSor:DELta ......................................................36
:CURSor:DISplay ...................................................37
:CURSor:SOURce .........................................................38
:CURSor:XPosition
Set
Query
Description Sets or returns the horizontal (X axis) cursor
position.
Same as: Cursor key → F5 (X-Y) →F2 (X1) or F3
(X2) + Variable knob
Syntax < Long > < Short >
:cursor:xposition
:cursor:xposition? :curs:xp
:curs:xp?
Parameter Cursor 1 or 2 Position in
seconds
1 Cursor X1
2 Cursor X2
Note When in the query mode, the returned data format
is as follows.
CH1, CH2, Math (+, -, Ч,ч): time (s)
Math (FFT, FFTrms): frequency (Hz)
Example :cursor:xdisplay 1
:cursor:x1position 3.000E-04 Puts the horizontal
cursor X1 at the 300us
position.
:channel:math 3
:cursor:xdisplay 1
:cursor:x1position?
→ 2.500E+03 Returns the X1 cursor
position as 2500Hz in
the Math FFT mode.