Avigilon View - Manual (Page 97)

Adding a Rialto™ Analytic Appliance Manually
If View cannot automatically discover the analytic appliance, you will need to add it manually.
1. Click the Add a device button.
2. Enter the IP Address or Network Name of the analytic appliance.
If you are adding a Rialto™ R-Series analytic appliance, click Add Rialto-R-Series... and enter the proper
ports for each module (blade).
3. Select a stream type from the Stream Over drop-down menu. If you are not sure which type to select,
consult Choosing Your Stream Type below.
4. Check the Use Custom Ports box and enter the port numbers for each port field if you are using port
mapping on a router with an externally accessible IP address.
5. Click OK.
Choosing Your Stream Type
UDP: This protocol uses the least bandwidth. However, it may not pass through all firewalls. If you’re having
trouble seeing live streaming video, select either TCP or HTTP(S).
TCP: If your firewall will not pass UDP traffic, select this protocol.
HTTP(S): This protocol uses the most bandwidth. If you use this protocol, you do not need separate ports for
RTSP and audio.
Adding a Rialto™ Analytic Appliance Manually 97