Avigilon Access Control Manager - Professional - Manual

2.Connect PC to Appliance
Connect a network cable directly from a DHCP
enabled port on your configuring PC to the RJ-45
port on the appliance.
Do not
connect the PC or appliance to the local
network at this point.
Connect to RJ-45 port
3. Open Web Browser
Open the web browser on the connected PC and
type this IP address: 169.254.1.250.
If you get a message indicating a connection or
security error, refer to Troubleshooting on the
other side of this sheet for instructions.
4. Login to the Application
When the log in screen appears, enter the login
name and password as “admin” then click Log in.
The Access Control Manager application main
menu appears.
5. Accept EULA
Before you can use the Access Control Manager
system, you must accept the end user license
agreement.
1. Click the link below the END USER LICENSE
NOT YET ACCEPTED error message.
2. Review the end user license agreement (EULA)
then enter your name and company.
3. Click Accept.
This package includes:
1. Access Control Manager Professional Appliance
8. Connect Appliance
to Network
After the appliance restarts, disconnect the
appliance from your configuring PC and move the
appliance to its final location in the system.
1. Using a standard Ethernet cable, connect
one end of the RJ-45 to an available RJ-45 port
on the appliance.
2. Connect the other end of the Ethernet cable to
the network.
For more information about configuring your
system, see the Help files provided with the Access
Control Manager application.
1. Plug In the Appliance
With the included power cord, plug the power plug
into the back of the appliance and the electric plug
into a wall outlet or surge protector.
6. Configure Port Settings
From the Access Control Manager application main
menu, perform these tasks:
1. From the top right corner, click Appliance.
2. Click the Ports tab.
3. From the Ethernet Configure page,
enter the required values. These include:
Name, IP Address, and Network Gateway.
4. Click the Save button.
Consult your IT manager for the IP Address and
Network Gateway values appropriate to your
installation.
If you do not need to change the appliance
hostname, manually restart the appliance now.
7. Edit Hostname
The default hostname for each appliance is ACM.
If you need to set a specific hostname for the
appliance, do so at this point before the appliance
is connected to the network.
1. Select the Appliance tab.
2. Enter a new Host Name.
3. Click the Save button.
The appliance automatically restarts.
Network Cable
Access Control Manager Professional
Getting Started Guide
QUICK START GUIDE
Connect Power Cord
2. Power Cord