Staking points with gnss – Spectra Precision Survey Pro v5.4 User Manual

Page 92

Staking Points

With GNSS

• Go to the

Stakeout menu and tap Stake Points

• Select the point to be staked using one of the two possible methods, as well

as the criterion allowing Survey Pro to prompt the next point to be staked
(see Selecting Points to Be Staked, “Next Point” Scenario on page 76)

• Set the rover antenna height.

• Tap

Stake. This opens the screen that will guide you to the point. Survey Pro

offers two different navigation modes to help you walk to the design point.

NOTE: In the example above, the direction to follow is provided as

Go North / Go East

instructions. Survey Pro can instead provide

Azimuth / Distance to the point if it’s

more convenient for you. Go to

Job > Settings > Stakeout tab to change the setting of

the

Display Directions As field. Point tolerance (different from acceptance criteria)

can also be set on this tab.

Tap on the

button to select one of these modes:

–

: The top of the screen will always show the selected reference point

or azimuth you select through the

Ref... button ([1]).

–

: The top of the screen will always show the direction in which you

are walking ([2]). A large red arrow will appear as you walk. The North
(N) and South (S) directions will be shown as well. You can also define
a reference point or azimuth using the

Ref... button. The resulting

direction will appear as a blue line starting from your current position.

• Walk toward the design point following the instructions on the screen (see

table below).

[1]

[2]