Seed Hawk AIRCART 2013 - Manual (Page 65)

SEED HAWK
®
AIRCART OPERATOR’S MANUAL 60
7.4.1 NORMAL OPERATION
To Power up turn the monitor, press the power key. The monitor will go through a short start
up procedure and will display a list of all the sensors that it recognizes from the installed
system. If a sensor that should be present on the system is not found a warning screen will
display asking you what you want to do. If multiple sensors are not found there will be multiple
warning screens displayed with the first expected sensor not found showing the first warning
screen. This will follow the order of the sensor installation screen. See trouble shooting guide
for possible reasons that a sensor or sensors are not found at start up.
If all the installed sensors are found, the monitor will display a list of found sensors and you will
need to press the soft key labeled “OK”. This will bring up the normal run screen. Items
displayed on the run screen can be user selected and the layout of the run screen can also be
user selected, REFER TO SECTION 7.2.4. At this point the system is ready for operation.