Seed Hawk AIRCART 2013 User Manual

Page 48

SEED HAWK

AIRCART OPERATOR’S MANUAL 43

The Menu Settings screen lists 12 choices:

1. MuxBus Sensor Setup: This is used to install and remove

sensors that operate on the

MuxBus network. These include the ground speed sensor, the Fan sensors, the Bin

Level

sensors, pressure and flow sensors.

NOTE: The VAR Controller listed is not used in this application

NOTE: The pressure sensor listed as a MuxBus sensor is available but a different sensor than
the Packing Pressure sensor. That sensor is connected to the hydraulic drive control module
and is communicated on the CAN network. It is called Shank Pressure in the layout item select
menu.

2. Global Settings: Use this menu selection to
set the units of measure, language, implement
width, the volume of the alarm, the backlight
and contrast of the screen, and the master
switch mode

3. Restore Settings to Defaults: This is used to
return all settings to factory defaults. (Warning?)

4. Ground Speed Calibration: This is used to
perform a field calibration for accurate ground
speed input. The accuracy of this calibration
affects application rates, acre accumulation, and
ground speed.