Seed Hawk AIRCART 2013 - Manual (Page 49)

SEED HAWK
®
AIRCART OPERATOR’S MANUAL 44
5. Meter Calibration: This is used to perform
stationary meter calibration tests and enter
accurate meter calibration information.
6. Clear Field Acres: Used to clear the field acre
register.
NOTE: The total acres cannot be cleared from the
Menu Settings screen. To clear the Total Acres a
USB drive with a program to clear the acres must
be used
7, 8, 9. These menu items are for use with Loup Electronics blockage monitoring and do not
currently apply to the Seed Hawk monitor.
10. Rate Controller Meter Setup: This menu
choice displays the application rate per meter
revolution determined by the individual meter
calibrations and allows you to enter different
values directly if desired. This screen is where the
pulses per revolution of the meter rotation
sensor can be entered if a value different than
the factory configuration is needed and the
increment rate for on the go application rate
changes is entered for each meter. This screen is
also where the low meter RPM alarm point is set.
There is a screen available under this choice for each installed meter. Use the soft key to select
the meter settings you want to review and adjust. Four meters are shown but meters not
installed cannot be accessed.