Seed Hawk AIRCART 2013 User Manual

Page 21

Text mode
Original mode

SEED HAWK

AIRCART OPERATOR’S MANUAL 16

4.1.3

PAIRING THE REMOTE

The remote should arrive ready for the customer to use, but if it becomes unpaired from the
receiver or a replacement remote is purchased, it is necessary to register the remote with the
receiver.

1. Switch OFF or DISCONNECT the power to

the

receiver.

2. Switch ON or reconnect the power to the

receiver. This opens a 20 second
registration window in the receiver. If you
are looking at the receiver circuit board, the
fault LED flashes.

3. Immediately

PRESS

and

HOLD

the

transmitter green button for a minimum of
10 seconds during this 20 second window.
When the Transmitter is registered the fault
LED goes out, and the set LED comes on.

4. The transmitter can now communicate with

the receiver, and a light on the receiver
flashes with each button press on the
transmitter.