Seed Hawk AIRCART 2013 - Manual (Page 30)

SEED HAWK
®
AIRCART OPERATOR’S MANUAL 25
4.3.4 CONVEYOR TRANSPORT POSITION
NOTE: Fill conveyor should always be secured
for transport, no matter how short the
distance. Clean out conveyor prior to transport
or storage.
1. Latch down the conveyor hopper then fold it up
on top of the conveyor tube. Be sure to secure it
with the tie down strap supplied.
2. Arrange the conveyor so that the upper rest is
positioned on the conveyor saddle at the front of
the aircart, Figure 20.
3. Raise the locking mechanism at the rear of the
aircart, Figure 21. The handle can be unlocked
and swung towards the aircart for transport.
4. Ensure to place pin back into locking mechanism
so that it cannot disengage during transportation,
Figure 22.
5. Push conveyor diverter valve back to the fan
position. Move hydraulics in both directions to
relieve pressure. This is most important for the
tilt cylinder so that it is not applying unnecessary
force on the support arms.
6. Secure outer arm locking mechanism, Figure 23.
Again ensure to replace pin so that lock does not
disengage during transportation.
Figure 20
Figure 21
Figure 22
Figure 23