beautypg.com

Replacing fan trays, Determining the need to replace a fan assembly, Time and items required – Brocade ICX 6650 Hardware Installation Guide User Manual

Page 67

background image

The power supply will immediately attempt to power up.

11. Verify that the LED on the new power supply displays steady green while the Brocade ICX 6650 is

operating (refer to

Replacing a power supply unit

on page 63). If the LED is not steady green,

ensure that the power supply is securely installed and seated properly.

Replacing fan trays

CAUTION

For the Brocade ICX 6650 devices, be sure that the airflow direction of the fan tray matches that
of the installed power supply unit. The power supplies and fan trays are clearly labeled with
either a green arrow with an "E", or an orange arrow with an "I."

Orderable Brocade ICX 6650 models include two redundant, hot-swappable fan units. However, it can
run on one power supply and one fan. In that case, the empty power supply and fan slots must be
covered using the filler panels.

ATTENTION

Maintain all power supply and fan assemblies in operational condition to provide redundancy.

CAUTION

Because the cooling system relies on pressurized air, do not leave any of the power supply and
fan assembly slots empty longer than two minutes while the switch is operating. If a power
supply or fan assembly fails, leave it in the switch until it can be replaced.

CAUTION

Disassembling any part of the power supply and fan assembly voids the warranty and regulatory
certifications. There are no user-serviceable parts inside the power supply and fan assembly.

Determining the need to replace a fan assembly

Enter the show chassis command in the command line interface to display fan status.

Time and items required

Replacing a fan assembly in the Brocade ICX 6650 should take less than two minutes to complete.

You need the following items to replace a fan assembly in the Brocade ICX 6650 switch:

A new fan assembly (must have the same part number and the same airflow label as the fan
assembly being replaced; refer to

FRU removal and replacement procedures

on page 62 for the

location of the airflow label)

A #1 Phillips screwdriver

Replacing fan trays

Brocade ICX 6650 Hardware Installation Guide

65

53-1003083-01