beautypg.com

Deleting an ip address, Connecting network devices, Connectors – Brocade ICX 6650 Hardware Installation Guide User Manual

Page 50: Connecting a network device to a fiber port, Installing a transceiver

background image

Syntax: router-interface venum

Syntax: interface venum

Deleting an IP address

Enter a command similar to the following to delete an IP address.

device(config-if-1/1/1)# no ip address 1.1.2.1

This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.

To delete all IP addresses from an interface, enter the following command.

device(config-if-1/1/1)# no ip address *

Syntax: no ip address ip-addr | *

Connecting network devices

Brocade devices support connections to other vendors’ routers, switches, and hubs, as well other
Brocade devices.

Connectors

For port pinouts, refer to

Pinouts and signaling

on page 74.

Connecting a network device to a fiber port

For direct attachment from the device to a Gigabit NIC, switch, or router, using a fiber-optic
transceiver, you need fiber cabling with an LC connector.

For information about transceivers supported on the Brocade ICX 6650, refer to the following Brocade
website:

http://www.myBrocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.pdf

To connect the device to another network device using a fiber port, you must perform the following
tasks:

Install a fiber-optic transceiver (SFP or SFP+).

Cable the fiber-optic transceiver.

Installing a transceiver

You can install a new transceiver in an SFP+ slot while the device is powered on and running.

While installing a transceiver, wear an ESD wrist strap with a plug for connection to a metal surface.

NOTE
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.

Deleting an IP address

48

Brocade ICX 6650 Hardware Installation Guide

53-1003083-01