Brocade ICX 6650 Hardware Installation Guide - Manual (Page 31)

4. Attach the front right bracket to the rail rack using two 10-32 x 5/8 in. screws and the appropriate
round-hole or square-hole retainer nuts. Refer to the following figure.
FIGURE 11 Installing the Brocade ICX 6650 in a 2-post rack
5. Repeat Step 3 to attach the left front bracket to the left front rack rail and tighten all 10-32 x 5/8 in.
screws to a torque of 25 in-lb (29 cm-kg).
Proceed to
Attaching a PC or terminal on page 32.
4-post rack mount installation
Kits for 4-post rack mounting are not included in the shipping carton and must be ordered separately.
NOTE
Use the following procedure when installing the Brocade ICX 6650 in a 4-post rack cabinet. For 2-post
cabinets, follow the procedures in
2-post rack mount installation on page 27.
Use the following steps to mount the Brocade ICX 6650 in a 4-post rack.
1. Remove the rack mount kit from the shipping carton. The kit contains the following:
• Two L-shaped mounting brackets.
• Four rack mount rails: two for side attach and two for rear attach racks.
• Thirty-two 8-32 x 5/16 in., panhead Phillips screws with patchlocks.
• Eight 10-32 x 5/8 in., panhead Phillips screws (torque to 25 in-lb, 29 cm-kg). Refer to item 1 in
the following figure.
4-post rack mount installation
Brocade ICX 6650 Hardware Installation Guide 29
53-1003083-01