Brocade icx 6650 operation, Led activity interpretation, Brocade icx 6650 front panel leds – Brocade ICX 6650 Hardware Installation Guide User Manual
Page 53
Brocade ICX 6650 Operation
LED activity interpretation
System activity and status can be determined through the activity of the LEDs on the switch.
There are three possible LED states: off (no light), a steady light, and a flashing light. Flashing lights
may be slow, fast, or flickering. The LED colors are blue, green, or amber.
Sometimes, the LEDs flash either of the colors during boot, POST, or other diagnostic tests. This is
normal; it does not indicate a problem unless the LEDs do not indicate a healthy state after all boot
processes and diagnostic tests are complete.
Brocade ICX 6650 front panel LEDs
The Brocade ICX 6650 has the following LEDs on the front panel:
•
Two power supply unit (PSU) bicolor status LEDs (green and amber) labeled PSU1 and PSU2
•
One DIAG status LED (green and amber)
•
One MS status LED (green and amber)
•
Four 1x40 GbE QSFP port status and activity LEDs (blue) which indicate the status of the 40 GbE
ports located on the rear panel
•
Eight 4x10 GbE QSFP-to-SFP breakout port status and activity LEDs (green) which indicate the
status of the 4x10 GbE breakout ports located on the rear panel
•
56 10 GbE bicolor status LEDs (green for 10 GbE and amber for 1 GbE) which indicate the mode
of operation
Brocade ICX 6650 Hardware Installation Guide
51
53-1003083-01