Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 39)

39
IM 04L31A01-02E
Program Control Related Setup Operations
Follow the flow chart below.
For further details on each function, see section 1.11, “Program Control Related
Settings” in the CX2000 User’s Manual (IM 04L31A01-01E) provided on the
accompanying CD-ROM.
#1
END
END
DISP/ENTER key
#1
DISP/ENTER key
ESC key * 2
#7
ESC key
Select pattern number and
then change the settings.
ESC key
DISP/ENTER
key
#2 to #7 ESC key
Change the settings on setting screens
#2 to #7.
[#7 Program-control parameters] appears
only if you set [Program control] to [On]
under [Control action, Input setting] on
page 38.
#1 Pattern initial setting
MENU key (switch to the Setting mode (Control))
> Next 1/2 soft key
#1 * 1
1
2
3
4
5 6
7
8
*1 If you set pattern parameters of other numbers
after this step, all settings up to that point are
cleared.
*2 If you did not change the settings on the Pattern
initial setting screen
ESC key * 2
To set a single pattern, carry out steps 1 to 8.
Setup Sequence
First, enter pattern initial settings (1 to 4 above).
Next, set [#2 Wait action setting] through [#7 Repeat action setting] (5 and 6 above).
Return to the Program-control parameters screen (7 and 8 above).
Set [#2 Event output setting] through [#4 Aux (Event group).]
Refer to the figure above for the following procedures.
Program Control Function (/PG1 and /PG2 Options)