Yokogawa IR400 - Manual (Page 68)

6 - 29
IM 11G02N01-01E
(2) Auto calibration
(3) External hold
Calibration
Output hold
Hold extending time.
Auto calibration start Auto calibration end
Time hold set to the gas flow time
Remote hold Input
Output hold
Close
Open
(4) Screen display during Holding
The “on Hold” message blinks on the measuring screen.
Since the screen displays the process of calibration is displayed during the manual calibration,
“on Hold” is not displayed even if the output signal is held, but the screen is displayed with the
hold extending time.
(5) If calibration is cancelled after the calibration gas is supplied regardless of during manual
calibration or auto calibration, the holding extending time will be performed.