Yokogawa IR400 - Manual (Page 57)

6 - 18
IM 11G02N01-01E
6.4.2.2 Forced stop of auto calibration
This mode is used to stop the auto calibration forcedly.
(1) In the User mode that is displayed, point
the cursor to “Setting of Auto
Calibration” by pressing the
or
key. Press the
ENT
key.
(2) In the “Setting of Auto Calibration” item
selection screen that appears, point the
cursor to “Auto Calibration Stop” by
pressing the
or key. Press the
ENT
key.
(“Auto Calibration Stop” appears when
the screen is selected while auto calibra
tion is performed.)
(3) “Stop” is highlighted, displaying a
message to confirm the stop of auto
calibration. Press the
ENT
key to stop the
auto calibration forcibly, and press the
ESC
key to cancel (not stopped).
( )
ENT
( )
ENT