Watlow Series SD31 PID with Optional Countdown Timer - Manual (Page 47)

Wa t l o w S e r i e s S D 3 1 ■ 45 ■ C h a p t e r 9 F a c t o r y
Display Parameter Name
Description
Settings Range
(Integer values for Modbus
in parentheses.)
Default Modbus*
(less 40,001
offset)
Read/Write
Appears if:
[``A;4]
[ A.4]
Input Calibrate, 4.0 mA
Calibrate the process current input to 4.0
mA (see “Calibrating the Series SD31”).
[``no]
[`yes] [``no] *NA Always active.
[`A;16]
[ A.16]
Input Calibrate, 16.0 mA
Calibrate the process current input to
16.0 mA.
[``no]
[`yes] [``no] *NA Always active.
[O1;1u]
[O1.1v]
Output 1 Calibrate, 1.0 Volt
The voltage process output transmits
1.000V.
[``no]
[`yes] [``no] *NA Process output installed
for Output 1.
[O1;9u]
[O1.9v]
Output 1 Calibrate, 9.0 Volt
The voltage process output transmits
9.000V.
[``no]
[`yes] [``no] *NA Process output installed
for Output 1.
[O1;4A]
[O1.4A]
Output 1 Calibrate, 4.0 mA
The current process output transmits
4.000 mA.
[``no]
[`yes] [``no] *NA Process output installed
for Output 1.
[O1;16]
[O1.16]
Output 1 Calibrate, 16.0 mA
The current process output transmits
16.000 mA.
[``no]
[`yes] [``no] *NA Process output installed
for Output 1.
* The Series SD31 controller can be calibrated only with the front panel controls. These parameters
are not accessible through serial communications.