Reaching the communications menu, 44 communications menu, Setup-comm – Watlow Series 988 User Manual

Page 72

4.44

WATLOW Series 988 User’s Manual

Setup Menus, Chapter 4

Setup-Comm

NOTE:
The Communications Menu
appears only on controllers
equipped with communications
hardware (98_ _-_ _ _ _-_R_ _,
98 _ _-_ _ _ _-_U_ _ or 98_ _-_ _
_ _-_S_ _).

See Data Communications with
the Series 988 Family of
Controllers for detailed informa-
tion on communications.

MODE

*Address

*Interface Type

Setup Prompt

Baud Rate

Data Bits and Parity

Protocol Type

Enter your settings,
from the controller's
upper display.

MODE

[COm]

[`Set]

[BaUd]

[Data]

[Prot]

[addr]

[IntF]

❸ Press the Mode key µ to step
through the prompts.

❹ Press the Up-arrow key > or the
Down-arrow key < to select one of
the prompt values.

Input

p. 4.2

Output

p. 4.18

Global

p. 4.34

Communications
Menu
p. 4.44

[Inpt]

[`Set]

[OtPt]

[gLbL]

[COm]

❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
Menus.

❷ Press the Up-arrow key > to select
one of the Setup Menus.

…

[baUD]

[9600]

[`300]

[1200]

[4800]

[Intf]

[`485]

[`422]

Reaching the Communications Menu

Figure 44 -
Navigating the
Communications Menu.

*Prompts may not
appear, depending
on controller config-
uration.