beautypg.com

Output 4 (p. 4.28), Ot4] [`al4, Setup-output – Watlow Series 988 User Manual

Page 56: Output 4, Alarm 4

background image

4.28

WATLOW Series 988 User’s Manual

Setup Menus, Chapter 4

Setup-Output

Output 4

Select the alarm condition for output 4.

[`AL4] de-energizes output 4 in an alarm condition.

[AL4n] energizes output 4 in an alarm condition.

[`Ot4] This prompt appears only on controllers equipped with output 4
hardware for a relay (98_ _-_ _ _ _-_B_ _, 98_ _-_ _ _ _-_D_ _ ,
98_ _-_ _ _ _-_E_ _ or 98_ _-_ _ _ _-_K_ _) or switched dc (98_ _-_ _ _ _-_C_ _).

Default

[`AL4]

[AL4n]

[`Ot4]

[`Ot4]

Alarm 4

Select the alarm type for alarm 4.

[`Pr1] uses a process signal from input 1.

[`dE1] uses a deviation from the input 1 signal.

[`Pr2] uses the process signal from input 2. This prompt does not

appear if the controller is not equipped with input 2 hardware or if
[`In2] is set to [``no] or [`Ei2].

[`dE2] uses a deviation from the input 2 signal. This prompt does not

appear if the controller is not equipped with input 2 hardware or if
[`In2] is set to [``no] or [`Ei2].

[rAtE] uses the rate of change at input 1 in degrees per minute.

[`AL4] This prompt appears only on controllers equipped with output 4
hardware for a relay (98_ _-_ _ _ _-_B_ _, 98_ _-_ _ _ _-_D_ _ ,
98_ _-_ _ _ _-_E_ _ or 98_ _-_ _ _ _-_K_ _) or switched dc (98_ _-_ _ _ _-_C_ _).

Default

[`Pr1]

[`dE1]

[`Pr2]

[`dE2]

[rAtE]

[``no]

[`AL4]

[`AL4]

[`AL4]

[`AL4]

[`AL4]

[`AL4]

˜

NOTE:
See Chapter 7 for
more information
on alarms.

[`Ot4]

[`AL4]