Watlow Series 988 - Manual (Page 38)

4.10 WATLOW Series 988 User’s Manual Setup Menus, Chapter 4
Setup-Input
[`In2]
Input 2 continued
from previous
page.
If Default
↓ ↓
98_ _-3_ _ _-_ _ _ _
no DIP slidewire potentiometer
[``no] [SLid] [`POt]
resistance [``In2] [`In2] [`In2]
only
98_ _-4_ _ _-_ _ _ _
no DIP current
current [``no] [SLid]
transformer [``In2] [`In2]
only
98_ _-5_ _ _-_ _ _ _
no DIP event 2
[``no] [`Ei2]
digital event [``In2] [`In2]
only
Remote Set Point
Enable a remote set point signal.
[`rSP] This prompt appears only if the controller is equipped with input 2
hardware and if
[`In2] is not set to [``no] and if [CntL] (in the Global
Menu) is set to [`nor].
Default
↓
[`OFF] [``On]
[`rSP] [`rSP]
[`rSP]