Watlow MICRODIN - Manual (Page 82)

6 . 2 Wa t l o w M i c r o D I N
Operations
MicroDIN Startup
Starting the Watlow MicroDIN for either one zone or several
in any thermal system requires successful completion of this checklist:
• Units securely mounted (see p. 3.3, 3.4)
• Proper sensor placement (see Watlow Application Guide)
• Correct input wiring (see p. 3.5, 3.6)
• Correct communications wiring (see p. 2.2 - 2.4, 3.5, 3.8, 3.9)
• Correct fusing installed (see p. 3.10, 3.11)
• Correct limit protection installed (see p. 3.10, 3.11)
• Correct power wiring (see p. 3.5, 3.7, 3.10, 3.11)
• PC communication EIA-485 card, or PC communications card to EIA-485
converter with correct wiring (see p. 3.8)
• Communications port correctly initialized (see PC communications card
document)
• MicroDIN Address set and recorded (see p. 2.7)
• MicroDIN baud rate set (see p. 2.7)
• MicroDIN-compatible software (see p. 2.9, A.2)
• MicroDIN correct order of parameter configuration (see p. 2.8 or A.19 chart)
• Record all system parameters (see p. 2.8 or A.19 chart)