Watlow MICRODIN - Manual (Page 23)

Wa t l o w M i c r o D I N 3 . 3
Install and Wire
Mounting the MicroDIN
To mount a MicroDIN on a DIN rail, hook the upper lip of the rail mounting
bracket onto the rail and press the controller down until the bottom lip of the
mount snaps onto the rail. To remove, as you push the back of the controller
down lift the front up until the bottom lip unsnaps from the rail.
To mount a MicroDIN on a panel, use the dimensions below to drill screw holes
for the mounting bracket.
DIN
rail
bracket for
panel mounting
(#6 screw
or m3.5 required)
Side View
Front View
.318 in
(8 mm)
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
3.750 in
(146 mm)
2.875 in
(73 mm)
5.062 in
(129 mm)
Attachment Angle 10 °
DIN
rail
4.225 in
(107 mm)
4.650 in
(118 mm)
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
Min. Clearance 2 in
(51 mm)
Min. Clearance
between rail
centerlines
5.750 in
(146 mm)
1.637 in
(42 mm)
1.650 in
(42 mm)
Top/bottom
mount
hole offset
Figure 3.3 -
Mounting a MicroDIN
controller.
ç
CAUTION:
Maintain the correct
spacing between rows of
controllers to allow
sufficient air circulation
and installation
clearance. Failure to do
so could result in
damage to equipment.
Use DIN EN 50022 35mm x 7.5mm Rail