Watlow 12LS Controller - Manual (Page 84)

4-51
NO Select the default segment for editing. Display advances to Edit Segment
Time.
BACK Return to the SETUP R/S PROFILE? prompt.
4.7.8 EDIT SEGMENT TIME
Use this menu to edit the segment time. Units are either Hours:Minutes or Minutes:Seconds
depending on the global time base selected.
|-----------------|
Display: ¦ x SEGMENT yy ¦
¦ SEG TIME ?hhh:mm¦
|-----------------|
The ? flashes.
x is the profile designator [A-L].
yy is the segment number [1-20].
hhh:mm is the current segment time [000:00 to 999:59]
YES Change the current segment time.
Lower display T= hh:mm
UP/DOWN Adjusts time.
ENTER Stores new segment time. Display advances
to Edit Segment Setpoint.
BACK Returns display to Edit Segment Number.
NO Leave segment time as it is. Display
advances to Edit Segment Setpoint.
BACK Returns display to Edit Segment Number.
4.7.9 EDIT SEGMENT SETPOINT
This menu allows setting of the segment setpoint. This is the setpoint for the end of the segment.
Entering a setpoint different from that of the previous segment will initiate a setpoint ramping
action over the length of the segment. Entering a setpoint the same as that of the previous segment
initiates a setpoint soaking action for the duration of the segment.
|----------------|
Display: ¦ x SEGMENT yy ¦
¦ SEG SETPT ?zzzz¦
|----------------|
The ? flashes.
x is the profile designator [A-L].
yy is the segment number [1-20].
zzzz is the setpoint for end of segment.