Watlow 12LS Controller - Manual (Page 42)

4-9
4.4 OPERATIONAL MENUS
All changes must start from the SINGLE LOOP display. The following changes can be made by pressing the
associated front panel key:
|----|
¦CHNG¦ o Adjust the setpoint on displayed loop.
¦ SP ¦
|----|
|----|
¦ MAN¦ o Change loop status from Manual to Auto
¦AUTO¦ or vice-versa.
|----|
|----|
¦RAMP¦ o If option is installed, this key is used
¦SOAK¦ to change status of a Ramp/Soak profile.
|----|
|-----------------------------------------------------|
¦ NOTE: Unless otherwise specified, in all examples ¦
¦of menu displays in the following discussions about ¦
¦editing and programming, the question mark (?) would ¦
¦ data or choice to be edited. When a menu is selected¦
¦ the x's would show the current data setting and the ¦
¦ question mark (?) would become an equal sign (=) ¦
|-----------------------------------------------------|
4.4.1 CHANGE SETPOINT
To change the setpoint of the channel being displayed, press this key :
|----|
¦CHNG¦
¦ SP ¦
|----|
The display will appear as in the following display using loop 5 as an example. The 1234 represent the current setpoint
value.
|----------------|
¦05 SETPOINT ? ¦
¦ 1234 ¦
|----------------|
Press NO or BACK to return to SINGLE LOOP display.
Press YES to change the setpoint.
Press UP or DOWN keys to change the value and ENTER to store it.